Name: JWD1-35JD Screw Type General Din-RaiL TB
Brand: SHANGHAI GKONCY ELECTRIC CO., LTD.

JWD1-35JD Screw Type General Din-RaiL TB

1. Wiring range: 0.75-35mm².

2. Utilizes a screw self-locking principle, featuring high clamping force and maintenance-free operation. This type of terminal block supports multi-wire connections at a single connection point, allowing for wire connection without pretreatment.

3. Enables multi-digit shorting or bridging.

4. Marking strips meet the marking needs of users in different scenarios.

5. Can be used in areas with explosion hazards (according to IEC/EN 60079).

6. Equipped with a grounding pin for rapid grounding.

Terminal thickness: 15.2
	Rigid conductor	Flexible conductor
	(mm²)
IEC 60947-7-2	0.75-50	0.75-35

Description		Type
Ground terminal: The yellow-green insulating housings can be mounted on the mounting rails and		JWD1-35 JD
Edge liaison part: Its role is the same as that of the central liaison part; with insulation on the back side; 10 digits that can be further divided at will	2 digits	BL 15/2
	3 digits	BL 15/3
	10 digits	BL 15/10
Edge liaison part: Its role is the same as that of the central liaison part; with insulation on the back side, inserted in the conductor holder, and clamped on the insulation housing of the terminal	2 digits
	3 digits
Prismatic conductor holder: A prismatic metal block used to compensate the pressed flat conductor
Terminal fastener: (thickness: 10) It is used to finally fix a large-current terminal; after it is pushed, it can be mounted on Type TH35/15 mounting rail, and it should be fixed with two screws.		ZG1
Tag: It can be quickly inserted in the upper grooves on both sides of the terminal as a whole for any identification. It has a total of 10 digits (to be divided at will); it is white.		ZP10

Terminal dimensions
Thickness / width	[mm]	15.2/50
Height (TH 35:7.5 / TH 35:15 / G 32:15)	[mm]	62/69.5/67
Technical data based on IEC/DIN VDE standards
Maximum rated working current / cross-sectional area	[A] / [mm²]	150/50
Rated impulse withstand voltage / degree of pollution	[kV]/-	8/31)
Over-voltage category / insulation material group	-/-	lll/l
Connection capacity
Flexible conductor with tubular bare terminal / tubular pre-insulated terminal	[mm²]	0.75 -35 / 0.75-35
Connection of multiple conductors (two conductors with the same cross-sectional area)
Rigid conductor / flexible conductor	[mm²]	0.75-16/0.75-10
Flexible conductor with tubular bare terminal	[mm²]	0.75-10
Flexible conductor with DEV-tubular pre-insulated terminal	[mm²]	0.75-6
Stripping length	[mm]	15
Screw for terminal position: screw type / torque	-/[Nm]	M 6 / 3.2-3.7
Central fastening screw: screw type / torque	-/[Nm]	M 5 / 2.5-3
Insulation material type		PA
Material flammability according to UL94		V0
Rated working voltage / rated working current / wire gauge	UL: [V]/[A]/AWG	-/-/18-1/0

Note: When an edge liaison part is used, a cable below 1.5 mm² should be used for a 2.5 mm² terminal; corresponding cables should be used for terminals with other cross-sectional areas (mm²).